300 Series USB Pairing/Reset Instructions

300 Series USB Pairing/Reset Instructions

If you wish to reset your 300 series mouse to its default settings, or pair it to a USB please follow the instructions below.
  1. Insert the USB receiver into your computer.
  2. While holding down both buttons, repeatedly turn the scroll wheel until both LED lights turn on (this may take up to 15 seconds)
  3. Let go of the buttons and hold the mouse close to the USB receiver. The lights will turn off when the mouse has "paired" with the receiver.
  4. Try using the mouse (you may need to click the button to start it). 


If both LEDs on your mouse light up during the reset process but it does not connect, there could a problem with your USB receiver. So try the process again via a different USB port to confirm, then if that does not work you may need a new USB receiver. Check the article below for details on this.
Replacement USB Receiver for 300 Series Mice

Alternately, if the two LED's do not light up, then unfortunately there is a problem with the mouse itself.



    • Related Articles

    • How do I pair my Pen-grip mouse with a USB receiver?

      To pair your Pen-grip mouse to a new USB receiver please follow the steps below: Only USB charger/receivers can be paired with. If you have a USB charger with orange Swiftpoint branding (as included with TRACPOINT, PadPoint, PenPoint, SurfacePoint, ...

    • How do I pair my Swiftpoint GT to a USB Receiver

      To pair your GT to a new USB receiver please follow the steps below. Ensure your USB receiver is attached to your computer. Ensure that your mouse is switched to the OFF position. Hold down all three (3) buttons on the mouse (front, rear and the ...

    • Swiftpoint GT Factory Reset

      To Factory Reset your GT and restore all of its internal settings to default, please follow the steps or video below. Remove any existing Swiftpoint GT Bluetooth pairings to any nearby computer or device. Make sure your USB receiver is connected to ...

    • How do I pair the Swiftpoint GT over Bluetooth?

      To pair your GT to a device over Bluetooth just follow the steps below. Go to the Bluetooth device menu in your system settings. Windows: Settings > Devices > Add Bluetooth device or other device > Bluetooth. MacOS: System Preferences > Bluetooth. ...

    • How do I pair with my Pen-grip mouse over Bluetooth?

      The pairing process for the Swiftpoint GT is mostly the same as below, but not all of the details apply. So please refer here instead for pairing instructions if you have a GT. To pair your pen-grip mouse mouse to a device over Bluetooth please ...