I can't change profiles using config mode anymore.
You may be stuck on the "Global Defaults" Profile. Simply set one of the other profiles to "active" in the Swiftpoint Driver and you will be able to cycle through them again using the config mode shortcuts.
Related Articles
Profiles & Sub-Profiles
Profiles are groups of mappings and settings that when active will define what all of the Zs various inputs and outputs do. Your current profiles are listed along the top of the driver. The profile currently active on your Z will be marked by an *, ...
X1 Control Panel Expert Mode Overview
Main Menu Starting from the top left of the Control Panels window you will find the Main Menu. Here you can access some of the key functionality detailed below. Save Mappings to Permanent Flash Memory in Mouse: This option allows you to export all of ...
Customizing a profiles button mappings
If you want to customize one of the pre-configured profiles, or are building your own profile from scratch. The following article will show you the different methods you can use to customize a button mapping. Demonstration Video Sean shows how you ...
Using "Repeat From" to loop actions in a macro
In the X1 Control Panel almost any output action, or sequence of output actions can be turned into a loop using the "Repeat From" action. This allows the creation of auto-fire/rapid-fire macros, or to automate some repetitive tasks. How to add a ...
Force percentages differ on the left and right buttons, or don’t go to 100%?
The force sensors are designed to work at full sensitivity in the center of the buttons, so clicking on the edges means it may not register full force. The sensors are calibrated at the factory so that the readings are the same on both the left and ...