Mac Control Panel Legacy Support

It is now possible to update your mouses firmware directly on macOS using the Control Panel. Just make sure you have version 1.2.0 (54) or newer, then pair with your mouse over Bluetooth and you will be prompted to update automatically.

If your mouse has an older version of firmware and you do not have Bluetooth to update it, the Control Panel will need to be in Legacy mode to work correctly.

You should see a prompt to switch to Legacy mode automatically if it is required for your mouse. But you can also switch between Legacy and Standard modes in the Control Panel via the Tools Menu. 

While using Legacy Firmware the Control Panels Presenter functions are not available. Disabling the Control panel will allow you to use some basic presenter functions, but it is necessary to update your firmware to access the SpotPoint and Laser Pointer functions.

• Related Articles

• Swiftpoint P3 Control Panel Download (For ProPoint, SurfacePoint, TracPoint, PadPoint, PenPoint, GoPoint & ErgoPoint)

  The Swiftpoint P3 Control Panel supports our current generation pen-grip mice including the following models; plus ErgoPoint: ProPoint SurfacePoint TracPoint PadPoint PenPoint GoPoint P3 Control Panel Downloads Windows 10/11: P3 Control Panel ...

• After Installing the Control Panel for Mac, my mouse buttons stop responding.

  The latest versions of the Swiftpoint Control Panel for Mac require your mouse to have firmware version 1.20 or newer installed. So if your mouse has an earlier version it will need to be updated.  To perform the update just pair with your mouse over ...

• Windows P3 Control Panel Clean Install

  If you are experiencing strange or unexpected behavior from your pen-grip mouse while the Control Panel is enabled, which disappears when you disable it. There may be a problem with your Control Panel installation. To resolve this please try ...

• The firmware update failed and now the LED on my mouse is always red.

  If a firmware update is unsuccessful your mouse may be left in a state where its LED will light up red whenever it is switched on. This means that the firmware update was only partially complete. Once in this state your mouse will not respond until ...

• P3 Control Panel - Desktop Presenter

  When using any of our pen-grip mice or ErgoPoint with the Swiftpoint P3 Control Panel on Windows you will have access to the "Desktop Presenter" tools. This is a set of tools that enhance your ability to perform presentations using your PC; either in ...