Something Went Wrong Error 104 while calibrating the Zs tilt angles to your desk.
If an Error 104 occurs while you are calibrating your Zs gyroscope, this indicates there is a communication issue between your Z and PC.
To resolve this try connecting your Z via a different USB port. Or if you are connecting via an external USB hub, please plug your Z directly into one of your PCs USB ports.
Related Articles
Something Went Wrong error on Swiftpoint Driver launch.
Summary If the Swiftpoint Driver is throwing a "Something Went Wrong" error every time you open it, and the UI is displayed incorrectly (as shown in the image below). There could either be a problem with one of the drivers configuration files, or the ...
I frequently need to reset my Zs tilt angles for my tilt outputs to work correctly.
This behavior from your tilt inputs can be caused by the auto-calibration system the Z uses. This system is intended to ensure the Zs tilt levels do not drift over time, but there are certain use cases where it can make matters worse. So if this ...
Tilt or Pivot Mappings are not responding
If any of your tilt or pivot mappings are not working , try setting the OLED mode on your profile to "Tilt Angles". This will display the current Roll, Pitch, and Yaw, values from the gyroscope, so you can identify if they are responding correctly. ...
Cleaning the Zs Middle Mouse Button Switch
If your middle mouse buttons tactile "click" is occurring, but no output is being sent there could either be a problem with your mouses configuration, or a hardware problem with the switch itself. Before proceeding with any hardware repairs please ...
"Error 2" During Firmware Update
If you are consistently encountering an Error 2 when you attempt to update the firmware of your Z. This indicates a problem with the serial number saved to your mouse. Fortunately we are able to resolve this remotely. So please just submit a support ...