Z - Reset Procedure

Z - Reset Procedure

To reset the settings saved in your Z's firmware to their defaults, follow the steps below.
  1. Unplug your Z.
  2. Hold down the main left and right mouse buttons.
  3. Plug your Z back in while continuing to hold both mouse buttons.
  4. A countdown should be displayed on the OLED screen along with the logo backlight flashing red and the mouse vibrating.
  5. Continue holding down both mouse buttons until the countdown completes.
Note: If the Swiftpoint driver is running when you do this, your custom settings will be loaded back onto the Z immediately. So if you want to test your Z with the default settings exit the Swiftpoint Driver before performing these steps. Or backup your profiles to a file then use the "Clear and Reset Settings in Driver and Mouse" option from the Swiftpoint Drivers main menu.


    • Related Articles

    • The OLED screen on my Z is no longer working.

      If your Zs OLED screen is no longer responding. Please try performing a reset of your Z with the steps below and confirm if there is any response from the OLED screen. Unplug your Z.  Hold down the main left and right mouse buttons. Plug your Z back ...
    • I frequently need to reset my Zs tilt angles for my tilt outputs to work correctly.

      This behavior from your tilt inputs can be caused by the auto-calibration system the Z uses. This system is intended to ensure the Zs tilt levels do not drift over time, but there are certain use cases where it can make matters worse. So if this ...
    • Is there a wireless version?

      We're not working on it now, but a wireless mouse in our professional range is something we investigated while developing the original Z. Unfortunately it wasn't feasible at the time, but we hope to revisit the idea in the future.
    • My mouse stops working after launching the X1 Control Panel

      If your mouse stops responding to mouse movement and button presses when it connects to the X1 Control Panel there may be a problem with the config file that the Control Panel is uploading to your mouse. To check if this could be the case first fully ...
    • The grip pads are coming loose on my mouse

      The grips pads on our Professional range mice are intended to be user replaceable, so they only use a light adhesive. But this should still hold them securely in place during normal use. So if some of the grips are starting to cause problems we can ...